|
DIRECTIONS:
Refer to flooring
manufacturer’s specific recommendations. Condition
the area to be installed, adhesive and flooring at
65°F (18°C) or above for 48 hours before,
during and 48 hours after installation. Floor must
be sound, smooth, dry, clean and free of excessive
moisture or alkali. Remove dirt, wax, loose paint
and all other foreign matter that would interfere
with a good bond such as curing agents and sealers.
- Stir any liquid on
the surface into the leveler.
- Pour a small amount
onto the floor and fill the embossed areas using
a smooth edge trowel.
- Hold the trowel on
a 60° angle, and spread diagonally using light
pressure.
- Smooth any ridges
that may form.
- Remove HENRY 550
from the raised unembossed areas with the trowel.
- Under most conditions,
only one application is necessary. The installer
may determine if a second application is required.
The second application should be made after the
first is completely dried.
|
Application
|
Recommended
Trowel
|
Coverage
|
| Felt-back
sheet flooring, linoleum, cork sheet |
Smooth
Edge Trowel |
200-400 sq. ft.
(22-44 sq yds/gal)
|
Click on the icons above to
calculate the amount of product you need!
CLEANUP:
- Wet
Adhesive: Clean, white cloth dampened with soapy
water.
- Dried
Adhesive: Clean, white cloth dampened with mineral
spirits; carefully following warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product information.
|
