|
DIRECTIONS:
Refer to
tile manufacturer's specific recommendations. Condition
the area to be installed, adhesive and flooring at
65°F (18°C) or
above for 48 hours before, during and 48 hours after
installation. Floor must be sound, smooth, dry, clean
and free of excessive
moisture or alkali. Remove dirt, wax, loose paint
and all other foreign matter that would interfere
with a good bond such as curing
agents and sealers. Moisture test results should meet
the flooring manufacturer's recommendations but should
not exceed 5
pounds/1000 sq ft/24 hours. Existing "cutback"
adhesive must be smooth with no ridges or puddles
evident.
- Stir any liquid on
the surface into the adhesive.
- Full spread adhesive
using the recommended trowel.
- Before installing
tile, allow adhesive to set open until dry to the
touch (tacky but no transfer to fingers), 30-90
minutes.
- After appropriate
open time, install tile. Within 24 hours, install
and fit all tile as recommended by the tile manufacturer.
- Roll with a 100 Ib.
roller if recommended by the tile manufacturer.
.Do not wet wash or strip tile for 5 days after
installation.
|
Application
|
Recommended
Trowel
|
Coverage
|
| 1/8"
tile |
|
350-400 sq. ft.
(38-44 sq yds/gal)
|
Click on the icons above to
calculate the amount of product you need!
CLEANUP:
- Wet
Adhesive: Clean, white cloth dampened with soapy
water.
- Dried
Adhesive: Clean, white cloth dampened with mineral
spirits; carefully following warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product information.
|
