4 Gallon: 0-42369-08854-1

DIRECTIONS:
Refer to carpet manufacturer’s specific recommendations. Condition the area to be installed, adhesive and carpet at 65°F (18°C) or above for 48 hours before, during and 48 hours after installation. Floor must be sound, smooth, dry, clean and free of excessive moisture and/or alkali. Remove dirt, wax, loose paint, and all other foreign matter that would interfere with a good bond such as curing agents and sealers.

• Stir any liquid on the surface into the adhesive.
  
• Full spread adhesive using recommended trowel. NOTE: Recommended trowel sizes are guidelines only, and are minimum requirements. Rough, porous concrete and heavily textured carpet backings may require deeper notches. A 100% transfer of adhesive into the carpet backing, while maintaining full coverage of the substrate, must be obtained.
  
• Install carpet immediately into wet adhesive.
  
• Within 60 minutes, cut, fit and reposition as recommended by the carpet manufacturer.
  
• Roll floor in both directions with a 75-100 lb roller and seal seams as recommended by the carpet manufacturer. Stiff carpet should be rolled again after 2 hours. Restrict heavy traffic over carpet for 24-48 hours.
  
• Protect carpet from exposure to water from cleaning and other sources for a minimum of 30 days after installation.

Application	Recommended Trowel	Coverage
Latex and urethane foam backed carpets		144-162 sq. ft. (16-18 sq yds/gal)
Other carpet backings		90-108 sq. ft. (10-12 sq yds/gal)

Click on the icons above to calculate the amount of product you need!

CLEANUP:

• Wet Adhesive: Clean, white cloth dampened with soapy water.
  
• Dried Adhesive: Clean, white cloth dampened with mineral spirits; carefully following warnings on the container.

WARNINGS:
Carefully read and follow all cautions and warnings on the product label. Refer to the Material Safety Data Sheet for additional product information.