|
|
|
|
Product
Info • Technical
Data
Installation Instructions
MSDS: USA: English
/ Spanish
• Canada: English / French
|
HENRY
377™ Carpet Pad Adhesive
|
|
|
|
| Typical
Use: |
Traffic
Type: |
| Installation
of carpet pad. |
Not
Designated |
| Bonds: |
Bonds
To: |
| All
carpet pads, including jute, hair, rubber, urethane, or
rebond. Residential use only. |
Concrete,
underlayments, wood substrates, and existing resilient
on all grade levels as recommended by the carpet pad manufacturer. |
| Warranty: |
| HENRY's Best 10 Year Warranty |
Back
to Top
|
TECHNICAL
DATA
| Base: |
Water-based/rubber-resin |
| Color: |
Beige |
| Taggant
Color: |
Yellow/Orange |
| Next
Generation: |
Solvent-free,
nonflammable |
| Open
Time: |
None |
| Working
Time: |
10
minutes NOTE: Working times vary based on job conditions,
substrates, temperature and humidity. |
| Size: |
Gallon |
| Shipping
Unit: |
Gallon:
4 gallons/ctn |
| Weight
Per Gallon: |
10.3
lbs |
| Quantity
Per Pallet: |
Gallon:
40 ctns |
| Shelf
Life: |
One
year if not opened |
| Freeze-Thaw
Stable: |
Keep
from freezing |
| UPC
Information: |
Gallon: 0-81833-37740-8 |
Back
to Top
INSTALLATION
INSTRUCTIONS
|
DIRECTIONS:
Refer to carpet pad manufacturer’s
specific recommendations. Condition the area to be installed,
adhesive and flooring at 65°F (18°C) or above
for 48 hours before, during and 48 hours after installation.
Floor must be sound, smooth, dry, clean and free of
excessive moisture or alkali. Remove dirt, wax, loose
paint and all other foreign matter that would interfere
with a good bond such as curing agents and sealers.
- Open
flip-top lid. Apply adhesive 3-4 inches away from
each wall, in criss-cross pattern, the full length
of all pad seams. Slight hand pressure on side of
container will help regulate flow.
- Adhesive
should be spread in an even film. A scrap of carpet
can be used to help even the film.
- Allow
the adhesive to set for 1-2 minutes, then lay pad
immediately. Walk pad into adhesive, making certain
to apply pressure at the seams.
CLEANUP:
- Wet
Adhesive: Clean, white
cloth dampened with soapy water.
- Dried
Adhesive: Clean, white
cloth dampened with mineral spirits; carefully following
warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product information.
|
Back
to Top
|
|
