TECHNICAL DATA

Base:	Water-based/rubber-resin
Color:	Cream
Taggant Color:	Yellow/Orange
Next Generation:	Solvent-free, nonflammable
Open Time:	Carpet: 10-20 minutes; no open time required for concrete; Sheet Flooring: 10-20 minutes over nonporous substrates and existing vinyl; approximately 10 minutes over wood; no open time required for concrete.
Working Time:	Up to 20 minutes over concrete; approximately 60 minutes over wood and other substrates NOTE: Working times vary based on job conditions, substrates, temperature and humidity.
Size:	Gallon, 4 Gallon
Shipping Unit:	Gallon: 4 gallons/ctn 4 Gallon: 1 pail
Weight Per Gallon:	9.5 lbs
Quantity Per Pallet:	Gallon: 30 ctns 4 Gallon: 48 pails
Shelf Life:	One year if not opened
Freeze-Thaw Stable:	To 10°F (-12°C) - Avoid low temperatures or multiple freeze-thaw cycles
UPC Information:	Gallon: 0-42369-19070-1 4 Gallon: 0-42369-08852-7

Back to Top

INSTALLATION INSTRUCTIONS

DIRECTIONS: Refer to flooring manufacturer’s specific recommendations. Condition the area to be installed, adhesive and flooring at 65°F (18°C) or above for 48 hours before, during and 48 hours after installation. Floor must be sound, smooth, dry, clean and free of excessive moisture or alkali. Remove dirt, wax, loose paint and all other foreign matter that would interfere with a good bond such as curing agents and sealers. Stir any liquid on the surface into the adhesive. Full spread adhesive using recommended trowel. NOTE: Recommended trowel sizes are guidelines only, and are minimum requirements. Rough, porous concrete and heavily textured carpet backings may require deeper notches. A 100% transfer of adhesive into the carpet backing, while maintaining full coverage of the substrate, must be obtained. Before installing floor, allow adhesive to set open for up to 10-20 minutes if installing over nonporous subfloors and existing vinyl floors (open time should be extended when high humidity conditions exist); approximately 10 minutes over wood; no open time required over concrete. After appropriate open time, install floor. Within 60 minutes (20 minutes over concrete), cut, fit and reposition as recommended by the flooring manufacturer. Roll floor in both directions with a 75-100 lb. roller and seal seams as recommended by the flooring manufacturer. Stiff carpets should be rolled again after 2 hours. Restrict heavy traffic for 24-48 hours. Protect carpet from exposure to water from cleaning and other sources for a minimum of 30 days after installation. Application Recommended Trowel Coverage Residential felt-back rotovinyl sheet flooring 140-160 sq. ft. (16-18 sq yds/gal) Latex and urethane foam backed carpets 144-162 sq. ft. (16-18 sq yds/gal) Other carpet backings 90-108 sq. ft. (10-12 sq yds/gal) Armstrong Felt-back sheet rotovinyl flooring over porous subfloors 125-150 sq. ft. (14-17 sq yds/gal) Armstrong Felt-back sheet flooring over nonporous subfloors 225-275 sq. ft. (25-31 sq yds/gal) Click on the icons above to calculate the amount of product you need! CLEANUP: Wet Adhesive: Clean, white cloth dampened with soapy water. Dried Adhesive: Clean, white cloth dampened with mineral spirits; carefully following warnings on the container. WARNINGS: Carefully read and follow all cautions and warnings on the product label. Refer to the Material Safety Data Sheet for additional product information.

Back to Top