TECHNICAL DATA

Base:	Water-based/rubber
Color:	White
Taggant Color:	Yellow/Orange
Open Time:	None recommended
Working Time:	Place panels within 30 minutes
Shipping Unit:	11 oz and 30 oz Cartridges, Gallon, 4 Gallons
Weight Per Gallon:	12 lbs
Shelf Life:	One year if not opened
Freeze-Thaw Stable:	To 10°F (-12°C) - Avoid low temperatures or multiple freeze-thaw cycles
VOC:	VOC content: 61 g/L; calculated and reported, SCAQMD 1169
UPC Information:	1 Gallon: 0-81833-31740-4

Back to Top

INSTALLATION INSTRUCTIONS

DIRECTIONS: Condition area to be installed, materials, and adhesive at 65° F (18° C) or over for 48 hours before, during and 48 hours after installation. Surface must be sound, smooth, dry, clean and free of excessive moisture or alkali. Remove dirt, wax, loose paint and all other foreign matter that would interfere with a good bond such as curing agents and sealers. This adhesive does not pass the "Butter Test". Do not use where odors may be transmitted to foodstuffs while the adhesive is being used and curing. Dry fit first panel vertically in a corner where walls intersect. Mark corner edge with dividers. Trim marked edge with saw to fit corner. Place back in corner and mark any cutouts. Use a fine-toothed saw to make cutouts. Mounting screws can be cut with a utility knife after panel is installed. Stir any liquid on the surface into the adhesive. Spread adhesive on back of panel using recommended trowel. Do not leave bare spots. Press down firmly on the trowel to avoid adhesive between ridges. Place panel against wall within 30 minutes. Press firmly over entire surface working from center to edges so that entire back of panel is in full contact with wall. Secure at top and bottom with 3 or 4 permanent nails. If wall irregularities prevent the adhesive from holding panels tight to the wall, press firmly again after 10 minutes, and use temporary bracing or a finishing nail to hold while the adhesive sets. For channel moldings and for permanent fasteners, follow the panel manufacturer's recommendations. Do not fit panels too tightly into moldings. A minimum 1/16" expansion space is needed. Remove wet adhesive residue with a clean, white cloth dampened with soapy water. Use mineral spirits for dried adhesive residue carefully following warnings on container. Application Recommended Trowel Coverage Trowel 50-60 sq. ft/gal Application Bead Coverage Cartridge gun 3/8" bead 125 lin ft per 30 oz cartridge Click on the icons above to calculate the amount of product you need! CLEANUP: Wet Adhesive: Water using a clean, white cloth Dried Adhesive: Mineral spirits using a clean, white cloth WARNINGS: EYE AND SKIN IRRITANT. Contains VM&P Naphtha and toluene, a chemical known to the state of California to cause birth defects or other reproductive harm. Avoid eye and skin contact. If eye contact occurs, flush with water for 15 minutes and call physician. Wash skin thoroughly with soap and water. Use with positive fresh air cross-ventilation. Do not take internally. If swallowed, do not induce vomiting. Call physician immediately. Keep container closed. KEEP OUT OF REACH OF CHILDREN. NOTE: Do not reuse container. Dispose of container and adhesive residue in accordance with federal, state and local waste disposal regulations. Do not flush adhesive down drains. Read label and Material Safety Data Sheet carefully before use. Recommended Architectural Specifications: "The adhesive as herein specified shall be HENRY 317 Multipurpose Construction Adhesive as manufactured by WW Henry Company, of Aliquippa, Pennsylvania."

Back to Top