|
DIRECTIONS:
- Remove
the screw cap of the seam sealer and replace it with
the nozzle applicator tip cap.
- Cut
tip to allow application of a 1/8" bead. Apply
1/8" continuous bead of seam adhesive to the
edge of the carpet where the face yarns enter the
backing.
- Apply
adhesive to one edge only.
- After
applying the bead, butt both edges of the carpet together
while the adhesive is still wet (approximately 5-10
minutes)
CLEANUP:
- Wet
Adhesive: Clean, white
cloth dampened with soapy water.
- Dried
Adhesive: Clean, white
cloth dampened with mineral spirits; carefully following
warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product information.
|
