|
DIRECTIONS:
Refer to flooring manufacturer’s
specific recommendations. Condition the area to be installed,
adhesive and flooring at 65°F (18°C) or above
for 48 hours before, during and 48 hours after installation.
Floor must be sound, smooth, dry, clean and free of
excessive moisture and/or alkali. Remove dirt, wax,
loose paint, and all other foreign matter that would
interfere with a good bond such as curing agents and
sealers.
- Stir
any liquid on the surface into the adhesive.
- Full
spread adhesive using recommended trowel. NOTE: Recommended
trowel sizes are guidelines only, and are minimum
requirements. Rough, porous concrete and heavily textured
carpet backings may require deeper notches. A 100%
transfer of adhesive into the carpet backing, while
maintaining full coverage of the substrate, must be
obtained.
- Before
installing floor, allow adhesive to set open for up
to 10 minutes if installing carpet or felt-back rotovinyl
over porous subfloors; 10–20 minutes if installing
felt-back rotovinyl over nonporous subfloors. Do not
let adhesive skin over.
- After
appropriate open time, install floor. Within 60–90
minutes, cut, fit and reposition as recommended by
the flooring manufacturer.
- Roll
floor in both directions with a 75–100 lb. roller
and seal seams as recommended by the flooring manufacturer.
Stiff carpets should be rolled again after 2 hours.
Restrict heavy traffic for 24-48 hours.
- Protect
carpet from exposure to water from cleaning and other
sources for a minimum of 30 days after installation.
|
Application
|
Recommended
Trowel
|
Coverage
|
| Residential
Felt-Back Rotovinyl Sheet Flooring |
|
140-160 sq. ft.
(16-18 sq yds/gal)
|
| Carpet |
|
90-108 sq. ft.
(10-12 sq yds/gal)
|
Click
on the icons above to calculate the amount of product
you need!
CLEANUP:
- Wet
Adhesive: Clean, white
cloth dampened with soapy water.
- Dried
Adhesive: Clean, white
cloth dampened with mineral spirits; carefully following
warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product information.
|
