Product Info • Technical Data
Installation Instructions
MSDS: USA: English / Spanish • Canada: English / French

HENRY 130 Thin Spread Floor Tile Adhesive

• 18-Hour Working Time
• Can Be Used Over "cutback" adhesive residue (reduces subfloor preparation)
• Moisture and Alkali Resistant
• Excellent Trowelability
• 5-Year Limited Warranty

Typical Use:	Traffic Type:
Installation of vinyl composition tile (VCT) and asphalt tile.	Not Designated
Bonds:	Bonds To:
Vinyl composition tile (VCT) and asphalt tile.	Concrete, existing asphalt “cutback” adhesive residue, underlayments, wood substrates, terrazzo, clean and abraded steel, stainless steel, aluminum, lead, copper, brass, and bronze, and existing resilient on all grade levels as recommended by the flooring manufacturer.
Warranty:
HENRY's 5 Year Warranty

TECHNICAL DATA

Base:	Water-based/asphalt/rubber emulsion
Color:	Black
Taggant Color:	Yellow/Orange
Next Generation:	Solvent-free, nonflammable
Open Time:	30-60 minutes
Working Time:	18 hours NOTE: Working times vary based on job conditions, substrates, temperature, and humidity.
Size:	4 Gallon
Shipping Unit:	4 Gallon: 1 pail
Weight Per Gallon:	9 lbs
Quantity Per Pallet:	4 Gallon: 48 pails
Shelf Life:	One year if not opened
Freeze-Thaw Stable:	To 10°F (-12°C) - Avoid low temperatures or multiple freeze-thaw cycles
UPC Information:	4 Gallon: 0-81833-13095-97

INSTALLATION INSTRUCTIONS

DIRECTIONS: Refer to tile manufacturer’s specific recommendations. Condition the area to be installed, adhesive and flooring at 65°F (18°C) or above for 48 hours before, during and 48 hours after installation. Floor must be sound, smooth, dry, clean and free of excessive moisture or alkali. Remove dirt, wax, loose paint and all other foreign matter that would interfere with a good bond such as curing agents and sealers. Stir any liquid on the surface into the adhesive. Full spread adhesive using recommended trowel. Before installing tile, allow adhesive to set open until dry to the touch (tacky but no transfer to fingers), approximately 30-60 minutes. After appropriate open time, install tile. Within 18 hours, cut and fit as recommended by the tile manufacturer. Roll tile with a 100 lb. roller if recommended by the tile manufacturer. Do not wet wash or strip tile for 5 days after installation. Application Recommended Trowel Coverage 1/8" Tile 200-250 sq. ft./gal Armstrong Tile 350-400 sq. ft/gal Click on the icons above to calculate the amount of product you need! CLEANUP: Wet Adhesive: Clean, white cloth dampened with soapy water. Dried Adhesive: Clean, white cloth dampened with mineral spirits; carefully following warnings on the container. WARNINGS: Carefully read and follow all cautions and warnings on the product label. Refer to the Material Safety Data Sheet for additional product information.